2 Pcs DIY Tray Resin Mold Tubala Silicone Dish Resin Mold Oval Epoxy Resin Rolling Tray Jewelry Plate Dish Casting Mold for Ring Holders DIY Craft Tray Office Home Decoration

DIY Tray Resin Mold, Tubala 2 Pcs Silicone Dish Resin Mold Oval Epoxy Resin Rolling Tray Jewelry Plate Dish Casting Mold for Ring Holders DIY Craft Tray Office Home Decoration How many oz of epoxy resin go into the mold? Generally 160ml/ 5.4oz to 100ml/ 5.7oz to completely fill the mold (80ml/ 2.7oz Part A 80ml Part B or 85ml/ 2.8oz Part A 85ml Part B) How to make a resin mold: 1. Pour resin into measurement cup, slowly stir to release bubbles. Adding glitter or pigment into it if you need 2. Just pour it nice and slow and give it adequate time to fully fill your mold (slowly fill it halfway, wait about a minute for it to settle, then finish pouring the rest) 3. Wait for the resin to completely cured 4. Simple to remove your crafts from the mold (waiting a full 24-36 hours before demolding) How to reduce bubbles? 1. Warm your resin before using it. (Note: torch or heat gun is not recommended to use with the molds directly as it may tear the molds) 2. Mix the resin and hardener slowly and deliberately. 3. After you've completed mixing the resin and hardener together, let it sit about 5 minutes. How to clean and store silicone molds: You can wash it with warm water and soap, then use a soft cloth to wipe clean. Specifications: Material: silicone Color: transparent Size: 18.5 x 10 x 2 cm/ 7.3 x 3.9 x 0.79 inch Package Included: 2 x Resin Tray Molds Notice: Wait for a full 24-36 hours before demolding. Clean the mold after each use to maintain gloss and extend mold life. Please let the resin stand for 5-10 minutes and then pour it into the mold to effectively reduce bubbles.