12V-24V DC 24A 240W 44Key IR Remote Controller for RGB LED Strip Light Lamp 5050 3528 SMD

Instructions for use: First connect the load line, the power line; power on to the connection line between the phenomenon of short circuit; When in operation, the remote control to the infrared receiving head, ensure no obstacles between the remote controller and the receiver; Note: on the DIY keys, and when it is first pressed, will enter the DIY color Mode, you can freely through the adjustment of the 6 custom color key to increase or decrease the R / G / B color (if another key is pressed, it will jump out of DIY color mode setting will jump). You can also save again you press the DIY key to set the color. The next time the key is pressed, it will display the last save color. Since there are 6 DIY key, so it can preserve 6 colors you like. They are independent, no influence each other. For example: if you press the DIY button 1, and then press DIY 2, DIY 1 will be invalid, until once again by pressing the DIY key 2, the color will be preserved. Prefix = V ns = "urn:schemas-microsoft-com:vml" note The standard product supply voltage DC12V~24V, shall not receive other voltage; Ensure that the wiring is correct before power on the short circuit, if the lamp does not work, should be promptly cut off, to prevent a short circuit burned the controller, And check the line if there is a problem; This product is not waterproof, if need to be placed outdoors or in damp places, the need for protection with waterproof box; Line LED lamp pole, R, G, public B should be corresponding to the output sorted +RGB and connection of product, do not correspond to or color; 5, the lamp strip lamp series with constant pressure cannot be too long, because the lamp itself has the pressure drop, which will cause the lamp brightness decline and the attenuation, This needs to be extended on the LED lamp more and RGB signal amplifier; 6, the use of infrared remote control should be the insulation film remote removed;